[KB140010][GASKET][TOUCH][FRONT] Gasket Reference by model

1.iSMON 8.4 Front Assembly:

2.iSPOS 10.4 PCT (GRB-D02 = F119)

3.iSPOS 15” PCT Touch Front Assembly

4.iSPOS 15” 5W Touch Front Assembly

5.iSPOS 17” Front

[KB140009][AMON][MSR] AMON MSR

To configure the MSR, please open a notepad and press Ctl+Alt+F10 to start the interactive setting function.

BTW, there is a dummy key inside the MSR, if it is removed, the MSR will not work.  This will need your understanding.

[KB140008][40][Keypad][APOS][POS] 40key keyboard layout

Need to inform the client the 40 key keypad cannot be programmed in their site.

If the client need to define any specific key value, please provide us the value by revising attached doc file and then we will make a specific firmware to meet their requirement.

Esc 1	Ctrl+F1 2	Ctrl+F2 3	← 4
Ctrl+F3 5	Ctrl+F4 6	Ctrl+F5 7	Ctrl+F6 8
Ctrl+F7 9	Ctrl+F8 10	Ctrl+F9 11	Ctrl+F10 12
Ctrl+F11 13	Ctrl+F12 14	Shift+F1 15	Shift+F2 16
Shift+F3 17	Shift+F4 18	Shift+F5 19	Shift+F6 20
Shift+F7 21	Shift+F8 22	Shift+F9 23	Ctrl+F10 24
7 25	8 26	9 27	- 28
4 29	5 30	6 31	+ 32
1 33	2 34	3 35	Enter 36 40
0 37	00 38	. 39

[KB140007][TOUCH][PCT][eGalaxy][Internal] PCT Touch tester by eGalaxyTester

This is for SENOR internal use, Please don't release out.

After unzip the tool, please launch eGalaxyTester.exe and then

 1.Use mouse to click “Start Test” and check if red circled items are passed.

2.During the test, it perform some manual test as attached video.

3.Please do the test as attached video.Check the final result is PASS or FAIL.

[KB140006][VFD] NEW VFD UPDATED with S-VDN5VD0000 Module

iSPOS

ROBOT POS

SHOPPOS

APOS

[KB140005][BIOS][BRIGHTNESS][KDS66]adjust the LCD brightness of KDS66T from BIOS

To adjust the LCD brightness of KDS66T from BIOS

1. Keep striking Del to enter BIOS setup while system powered on.

2. Strike Enter on PC Health Status

3. Strike enter on the LCD Back Light Control to select the required brightness level.

4. After set the required brightness level, strike F10 -> Y -> Enter to save and exit the BIOS setup.  Finished.

[KB140004][iCPOS]Quick manual to Discharge / Set up iCPOS series Front Set

1.Remove the screws.

2.Turn over the unit to have the touch panel faced up, and then use a thin mylar sheet to detach the rear casing and the front panel.  Below mylar sheet is from SHOP POS Power supply.

To install the front panel. just align the front panel to the rear casing.

Snap fit the front panel to the rear casing.